Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 200 S, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Module, Driver Door (DDM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1852 | DRIVER WINDOW SWITCH STUCK |
| B1854 | DRIVER WINDOW CONTROL CIRCUIT LOW |
| B1858 | DRIVER WINDOW POSITION SENSOR POWER SUPPLY LOW |
| B185A | DRIVER WINDOW POSITION SENSOR CIRCUIT PERFORMANCE |
| B1868 | DRIVER PASSENGER WINDOW SWITCH CIRCUIT STUCK |
| B18D5 | DRIVER DOOR PAWL SWITCH STUCK - JS27 |
| B190E | DRIVER WINDOW SWITCH CIRCUIT LOW |
| B190F | DRIVER WINDOW SWITCH CIRCUIT HIGH |
| B1914 | DRIVER WINDOW CONTROL 2 CIRCUIT LOW |
| B19F9 | LEFT REAR WINDOW SWITCH CIRCUIT STUCK - JS27 |
| B19FD | RIGHT REAR WINDOW SWITCH CIRCUIT STUCK - JS27 |
| B1DA7 | SWITCH POWER SUPPLY CIRCUIT LOW |
| B210D | BATTERY VOLTAGE LOW |
| B210E | BATTERY VOLTAGE HIGH |
| B2218 | DRIVER DOOR MODULE INTERNAL |
| U0141 | LOST COMMUNICATION WITH IPM (FCM/TIPM) |
| U0151 | LOST COMMUNICATION WITH OCCUPANT RESTRAINT CONTROLLER (ORC) |
| U0155 | LOST COMMUNICATION WITH CLUSTER/CCN |
| U0156 | LOST COMMUNICATION WITH EOM |
| U0164 | LOST COMMUNICATION WITH HVAC CONTROL MODULE |
| U0167 | LOST COMMUNICATION WITH INTRUSION TRANSCEIVER CONTROL MODULE |
| U0168 | LOST COMMUNICATION WITH VEHICLE SECURITY CONTROL MODULE (WIN) |
| U0169 | LOST COMMUNICATION WITH SUNROOF CONTROL MODULE |
| U0184 | LOST COMMUNICATION WITH RADIO |
| U0186 | LOST COMMUNICATION WITH AUDIO AMPLIFIER |
| U0196 | LOST COMMUNICATION WITH VEHICLE ENTERTAINMENT CONTROL MODULE |
| U0197 | LOST COMMUNICATION WITH HANDS FREE PHONE MODULE |
| U0200 | LOST COMMUNICATION WITH PASSENGER DOOR MODULE |
| U0206 | LOST COMMUNICATION WITH FOLDING TOP CONTROL MODULE |
| U0208 | LOST COMMUNICATION WITH HEATED SEAT CONTROL MODULE |
| U1000 | CAN B BUS (+) CIRCUIT |
| U1001 | CAN B BUS (-) CIRCUIT |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.