Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Chrysler 200 Limited, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Orc Jumper Harness
- Connect the ORC jumper harness (2) to the body harness (3).
- Connect the ORC jumper harness connector (4) to the ORC (1).
- Install the center console. Refer to HOUSING, SHIFTER, INSTALLATION .
WARNING:
Do not connect the battery negative cable. Refer to DIAGNOSIS AND TESTING . Serious or fatal injury may result if the system test is not performed first.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.