2010 Chrysler 300 V6-2.7LFACTORY OEM SERVICE PROCEDURE

Passive Entry Module - Removal





REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Factory service manual diagram




1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. Instrument Panel Glove Box - Removal.
3. Reach through the glove box opening (5) and above the glove box latch striker (4) to access and disconnect the two instrument panel wire harness connectors (2) from the Passive Entry Module (PEM) (3) connector receptacles.
4. Remove the two screws (1) that secure the PEM to the instrument panel base trim substrate.
5. Remove the PEM through the glove box opening.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.