Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler Sebring Convertible V6-2.7LFACTORY OEM SERVICE PROCEDURE
Engine Torque Specifications
TORQUE
2.7L, EER
CYLINDER HEAD
Tighten bolts in sequence shown, using the following steps and torque values:
Step 1: Bolts 1-8 48 Nm (35 ft. lbs.)
Step 2: Bolts 1-8 75 Nm (55 ft. lbs.)
Step 3: Bolts 1-8 75 Nm (55 ft. lbs.)
Step 4: Bolts 1-8 +90° Turn
CAUTION: Do not use a torque wrench for this step.
Step 5: Bolts 9-11 28 Nm (250 in. lbs.)
HEAD BOLT REUSE/REPLACE
The cylinder head bolts must be examined BEFORE reuse. If the threads are necked down the bolts must be replaced
INTAKE MANIFOLD
Lower
Upper
Camshaft Bearing Cap
MAIN BEARING CAP
NOTE: The main bearing cap bolts must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, and lastly the main cap tie (horizontal) bolts.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.