Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler Sebring Convertible V6-2.7LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
Diameter 53.51-53.49 mm (2.1067-2.106 in.)
Bearing Clearance 0.024-0.064 mm (0.001-0.0026 in.)
Out of Round (Max.) 0.015 mm (0.0006 in.)
Taper (Max.) 0.015 mm (0.0006 in.)
Side Clearance 0.13-0.38 mm (0.0052-0.015 in.)
Side Clearance (Max.) 0.4318 mm (0.017 in.)
Piston Pin Bore Diameter 22.007-22.015 mm (0.8665-0.8668 in.)
Bearing Bore Out of Round (Max.) 0.004 mm (0.0002 in.)
Total Weight (Less Bearing) 529.9 ±7 grams (18.6917 ±0.247 oz.)
Connecting rod cap - Bolts 27 Nm +1/4 Turn (20 ft. lbs +1/4 Turn)
Bearing Clearance 0.024-0.064 mm (0.001-0.0026 in.)
Out of Round (Max.) 0.015 mm (0.0006 in.)
Taper (Max.) 0.015 mm (0.0006 in.)
Side Clearance 0.13-0.38 mm (0.0052-0.015 in.)
Side Clearance (Max.) 0.4318 mm (0.017 in.)
Piston Pin Bore Diameter 22.007-22.015 mm (0.8665-0.8668 in.)
Bearing Bore Out of Round (Max.) 0.004 mm (0.0002 in.)
Total Weight (Less Bearing) 529.9 ±7 grams (18.6917 ±0.247 oz.)
Connecting rod cap - Bolts 27 Nm +1/4 Turn (20 ft. lbs +1/4 Turn)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.