Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler Sebring Convertible V6-2.7LFACTORY OEM SERVICE PROCEDURE
Knock Sensor - Installation
2.7L
CAUTION: Over or under tightening effects knock sensor performance resulting in possible improper spark control.
1. Install knock sensor (3) and nut (2) onto stud (1).
2. Tighten knock sensor nut to 15 Nm (11 ft. lbs.).
3. Attach electrical connector to knock sensor.
4. Position the water housing outlet tube (4) to the cylinder heads and loosely install four bolts (1).
5. Attach water housing outlet tube (4) to the retaining clip (6) at rear of engine.
6. Tighten the four bolts (1) to 3 Nm (30 in. lbs.).
7. Connect electrical connector (2) to the coolant temperature sensor.
8. Install heater hose (5) to water housing outlet tube (4) at rear of engine.
9. Install radiator upper hose (3) to water housing outlet tube (4).
10. Install intake manifold Intake Manifold - Installation.
11. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
12. Fill cooling system Service and Repair.
13. Operate engine until it reaches normal operating temperature. Check cooling system for correct fluid levels.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
