Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler Sebring Convertible V6-2.7LFACTORY OEM SERVICE PROCEDURE
Removal
GAS
The main fuel level sensor located on the fuel pump module is not serviceable for both front wheel drive (FWD) and all wheel drive (AWD) vehicles. Only the main fuel level sensor for the flex fuel vehicle (FFV) is serviceable. The secondary fuel level sensor for the AWD vehicles is serviceable.
1. If the fuel level sensor fails replace the fuel pump module, Fuel Pump Module - Removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.