Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
MPS6 Quick Learn Procedure
The quick learn procedure requires the use of the scan tool. This program allows the electronic transaxle system to recalibrate itself. This will provide the best possible transaxle operation.
- Transmission Control Module Assembly (includes controller, valve body and solenoid body) Replacement
- Dual Clutch Assembly Replacement
- Transmission Overhaul (Disassembly and Reassembly)
To perform the Quick Learn Procedure, the following conditions must be met:
- Shifter must be in P (park) position
- Park brake must be applied
- Service brake must be applied
- The engine must be running
- Transmission oil temperature must be above 18° C (64° F) and below 93° C (200° F)
- Plug the scan tool into the diagnostic connector. The connector is located under the instrument panel.
- Go to the Transmission screen.
- Go to the Miscellaneous screen.
- Select Quick Learn Procedure. Follow the instructions of the scan tool to perform the Quick Learn Procedure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.