2009 Chrysler Sebring Base, 2D Convertible, EDGFACTORY OEM SERVICE PROCEDURE

Diagnostic Test

  1. INSPECT THE A/C HEATER CONTROL FOR DAMAGE 
    1. Inspect the A/C Heater Control for damage.

      Is the A/C Heater Control damaged?

      Yes 

      No 

      • Go to step  2
  2. INSPECT FOR OBJECT OR SUBSTANCE CAUSING THE EBL MODE SWITCH TO STAY OR STICK IN A PUSHED POSITION 
    1. Inspect the A/C Heater Control for anything that would cause the EBL mode switch to stay or stick in a pushed position.

      Is anything present that would cause the EBL mode switch to stay or stick in a pushed position?

      Yes 

      No 

      • Go to step  3
  3. CHECK FOR NORMAL EBL MODE SWITCH AND STATUS INDICATOR FUNCTION 
    1. Turn the ignition on.
    2. Press the EBL mode switch on and off several times while observing the EBL status indicator.

      Does the EBL status indicator turn on and off?

      Yes 

      • Go to step  4

      No 

  4. VERIFY THAT DTC B10C2 - REAR DEFROST SWITCH STUCK IS STILL ACTIVE 
    1. With the scan tool, erase DTCs.
    2. Turn the ignition off, wait 10 seconds, and then turn the ignition on. Wait 1 minute before proceeding.
    3. With the scan tool, read DTCs.

      Does the scan tool display active: B10C2 - REAR DEFROST SWITCH STUCK?

      Yes 

      No 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.