2009 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE

Transmission Range Sensor - Installation






INSTALLATION

Factory service manual diagram




Factory service manual diagram





The valve body assembly (2) must be removed to gain access to and replace the transmission range sensor (1).

1. Install transmission range sensor (1).

Factory service manual diagram




Factory service manual diagram





2. Tighten retaining screw (3) to 5 Nm (45 in. lbs.).

Factory service manual diagram




Factory service manual diagram





3. Install manual shaft seal (1).

Factory service manual diagram




Factory service manual diagram





4. Guide park rod rollers (1) into guide bracket (3) while installing valve body to the transaxle case.

Factory service manual diagram




Factory service manual diagram





5. Install the valve body-to-case bolts (1)and torque to 12 Nm (105 in. lbs.).

Factory service manual diagram




Factory service manual diagram





6. Install the oil filter (1). Inspect the o-ring (2) for damage and replace as necessary.

Factory service manual diagram




Factory service manual diagram





7. Install an 1/8' bead of RTV (2)and install pan (1) to case.

Factory service manual diagram




Factory service manual diagram





8. Install oil pan bolts (1) and torque to 19 Nm (165 in. lbs.) torque.
9. Lower vehicle.
10. Connect transmission range sensor connector.
11. Install manual valve lever to manual valve.

Factory service manual diagram




Factory service manual diagram





12. Install gear shift cable (1) to manual valve lever (2).

Factory service manual diagram




13. Install the battery tray (1).

Factory service manual diagram




Factory service manual diagram





14. Install the battery (1) and hold down clamp.

Factory service manual diagram




Factory service manual diagram





15. Install air cleaner assembly (1).
16. Connect battery cables.
17. Fill transaxle with ATF+4 (Automatic Transmission Fluid-Type 9602). Refer to Fluid Level and Condition. Fluid Level and Condition Check

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.