2009 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE

Speed Control Switch - Installation






INSTALLATION

Factory service manual diagram




The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.

Factory service manual diagram




WARNING: If removal of airbag module is necessary, refer to the restraint systems.

1. Connect the electrical connector.

Factory service manual diagram




Factory service manual diagram





2. Install switch and tighten the screws (1) to 1.6 Nm (15 in. lbs.). Make sure rubber seal is in place around switch.
3. Install airbag, refer to the Restraint Systems.
4. Install the negative battery cable.
5. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.