2009 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Airbag System Verification Test

  1. AIRBAG SYSTEM VERIFICATION TEST 
    1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.
      WARNING: Turn the ignition on, then reconnect the 12-volt battery. Wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
    2. Connect the scan tool to the Data Link Connector - use the most current software available.
    3. If sent here from an Occupant Classification System (OCS) related diagnostic procedure or if repairs were made to the OCS, perform the OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Occupant Classification (OCM) - Standard Procedure .
    4. With the scan tool, erase stored DTCs in ORC.
    5. Turn the ignition off, and wait 15 seconds, then turn the ignition on.
    6. Wait one minute, and read active DTCs in all Airbag System Modules.
    7. Read the stored DTCs in the ORC.

      Are any DTCs present or if the original condition still present?

      Yes 

      No 

      • Repair is complete.
Chapter Navigation
Return to Chapter: Standard Procedure
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.