2009 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Possible Causes

Possible Causes 
TIPM FUSE 28 SUPPLY VOLTAGE LOW
(F200) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT OPEN
(F200) FUSED IGNITION SWITCH OUTPUT (RUN-START) CIRCUIT SHORTED TO GROUND
OPEN TIPM FUSE 28
OCCUPANT RESTRAINT CONTROLLER (ORC)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.