Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Analog Clock Module | Right side of dash. See Figure. |
| Anti-Lock Brake Module | Left side of engine compartment, on bottom of hydraulic control unit. See Figure. |
| Compass Module | At top center of windshield. See Figure. |
| Fuel Pump Module | On fuel tank. See Figure. |
| Hands Free Module | Left center of instrument panel. See Figure. |
| Occupant Restraint Controller Module | Center body floor. See Figure. |
| Powertrain Control Module | On firewall, behind power distribution center. See Figure. |
| Radiator Cooling Fan Module | Front of radiator. See Figure. |
| Satellite Receiver | Left "C" pillar. See Figure. |
| Sentry Key Remote Entry Module | On steering column, near ignition lock cylinder. See Figure. |
| Steering Wheel Control Module | Left side of dash. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
