2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Coil Spring

Fig 1: Locating Mounting Flange/Frame
GC0033692Courtesy of CHRYSLER LLC
  1. Install the spring into the spring pocket.
  2. Swing the lower control arm (2) up and install the bolt attaching the control arm to the frame (1).
    Fig 2: Locating Rear Spring
    GC0033666Courtesy of CHRYSLER LLC
  3. Carefully release the spring (1) insuring the spring properly aligns with the spring perch detents.
    Fig 3: Rear Shock Absorber Mounting
    GC0033667Courtesy of CHRYSLER LLC
  4. Install the lower shock mount (1) to the lower control arm. Tighten to 55 N.m (41 ft. lbs.).
    Fig 4: Locating Cover Bolts
    GC0033665Courtesy of CHRYSLER LLC
  5. Install the control arm cover and bolts (1).
  6. Install the wheel and tire assembly. Refer to STANDARD PROCEDURE .
  7. Check vehicle alignment. See STANDARD PROCEDUREΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.