Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
P0521-Engine Oil Sensor Water Contamination: Notes
- When Monitored : With the engine running.
- Set Condition
: Anytime the Powertrain Control Module (PCM) senses the Oil Quality value is above 4.0.NOTE: The engine oil must be changed before this test can be accurately conducted.
| Possible Causes |
| WATER IN THE OIL |
| CONTAMINATED OIL |
| OIL SENSOR SIGNAL CIRCUIT OPEN |
| OIL SENSOR SIGNAL CIRCUIT SHORT TO GROUND |
| OIL SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE |
| 5-VOLT SUPPLY CIRCUIT OPEN |
| 5-VOLT SUPPLY CIRCUIT SHORT TO GROUND |
| 5-VOLT SUPPLY CIRCUIT SHORT TO VOLTAGE |
| 5-VOLT SUPPLY CIRCUIT SHORT TO SENSOR GROUND CIRCUIT |
| OIL SENSOR SIGNAL CIRCUIT SHORT TO SENSOR GROUND CIRCUIT |
| OIL SENSOR SIGNAL CIRCUIT SHORT TO 5-VOLT SUPPLY CIRCUIT |
| SENSOR GROUND CIRCUIT OPEN |
| MANIFOLD ABSOLUTE PRESSURE SENSOR |
| ENGINE OIL SENSOR |
| POWERTRAIN CONTROL MODULE |
For a complete Powertrain Control Module Circuit Diagram, refer to SCHEMATICS AND DIAGRAMS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.