Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
P0410-Secondary Air Injection System: Notes
- When Monitored : Once per driving cycle with the engine at idle, air conditioning is off, barometric pressure is greater than 78 kPa (11 psi), engine coolant temperature is greater than 50°C (122°F) and no other DTC set.
- Set Condition : When the test is enabled, the O2 Sensor must increase by at least 23% (rich).
| Possible Causes |
| AIR PUMP VOLTAGE SUPPLY CIRCUIT OPEN |
| AIR PUMP VOLTAGE SUPPLY CIRCUIT SHORT TO GROUND |
| AIR PUMP GROUND CIRCUIT OPEN |
| CRACKING, MISSING, MISROUTED, OR PLUGGED VACUUM LINES. |
| AIR PUMP SWITCHOVER VALVES |
| AIR PUMP RELAY |
| AIR PUMP |
| POWERTRAIN CONTROL MODULE |
For a complete Powertrain Control Module Circuit Diagram, refer to SCHEMATICS AND DIAGRAMS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
