Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Fuel Level Sending Unit/Sensor
| 1 - ELECTRICAL HARNESS CONNECTOR |
| 2 - FUEL LEVEL SENDING UNIT |
| 3 - SEAL |
| 4 - FUEL TANK |
| 5 - SPECIAL TOOL 9240 |
- Disconnect the negative battery cable.
- Drain the fuel tank. See STANDARD PROCEDUREΒ .
- Remove the cargo area interior trim panels.
- Remove the fuel tank partition retaining bolts and remove the fuel tank partition.
- Disconnect the fuel level sending unit/sensor harness connector (1).NOTE: Place a shop towel around the fuel level sending unit/sensor to catch any excess fuel during disassembly.
- Install Special Tool 9240 (5) and rotate the fuel level sending unit/sensor (2) counterclockwise.
- Remove the fuel level sending unit/sensor (2) from the fuel tank (4).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
