2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor Clutch At lower left front of engine. See Figure.
Antenna C1 (Convertible) At left rear quarterpanel.
Antenna C1 (Coupe) At underside of lower liftgate. See Figure.
Antenna C2 At underside of lower liftgate. See Figure.
BAS Brake Booster C1 At left rear of engine compartment.
BAS Brake Booster C2 At left rear of engine compartment.
Battery At right rear of engine compartment. See Figure.
Clockspring Top of steering column.
Coil On Plug 1 On right valve cover.
Coil On Plug 2 On right valve cover.
Coil On Plug 3 On right valve cover.
Coil On Plug 4 On left valve cover. See Figure.
Coil On Plug 5 On left valve cover. See Figure.
Coil On Plug 6 On left valve cover. See Figure.
Data Link Connector Under left side of dash.
Driver Seat Belt Tensioner Squib In driver seat belt tensioner.
Generator At lower right front of engine. See Figure.
Left Side Air Bag Squib Rear of left door.
Passenger Air Bag Squib Behind right side of dash.
Passenger Seat Belt Tensioner Squib In passenger seat belt tensioner.
Passenger Seat Occupant Simulator Behind passenger footwell. See Figure.
Power Amplifier Behind passenger footwell. See Figure.
Right Side Air Bag Squib Rear of right door.
Sentry Key Antenna Ring On ignition key cylinder.
Siren At base of windshield, under grille.
Supercharger Clutch (SRT) On front of engine.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.