2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G100 At left side of engine compartment. See Figure.
G101 At right side of engine compartment. See Figure.
G104 At top front of engine.
G107 At right side of engine compartment. See Figure.
G200 Behind upper left side of dash.
G201 At left kick panel. See Figure.
G202 Under center console. See Figure.
G203 Under center console. See Figure.
G204 At right kick panel. See Figure.
G205 At upper left rear of passenger compartment. See Figure.
G206 At right kick panel. See Figure.
G300 Left side of trunk, behind trim panel. See Figure.
G301 At right side of trunk. See Figure.
G302 Top of liftgate. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.