Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G100 | At left front of engine compartment. See Figure. |
| G101 | At right front of engine compartment. See Figure. |
| G102 | At right side of engine compartment. See Figure. |
| G104 | Right side of engine compartment. See Figure. |
| G104 (2.7L) | On right side of engine. See Figure. |
| G104 (3.5L) | On right side of engine. See Figure. |
| G104 (5.7L) | On right side of engine. See Figure. |
| G104 (6.1L) | Top of right cylinder head cover. See Figure. |
| G105 (2.7L & 3.5L) | On rear of engine. |
| G105 (5.7L) | On rear of engine. See Figure. |
| G105 (6.1L) | Rear of engine. See Figure. |
| G106 (2.7L) | On left side of engine. See Figure. |
| G106 (3.5L) | On left side of engine. See Figure. |
| G106 (5.7L) | On rear of engine. See Figure. |
| G106 (6.1L) | Left rear of cylinder head. See Figure. |
| G107 (3.5L) | On right side of engine, near generator. |
| G108 (3.5L) | On left side of engine. See Figure. |
| G109 | Right side of engine compartment. See Figure. |
| G109 (6.1L) | Top of right cylinder head cover. See Figure. |
| G200 | Behind left side of dash. See Figure. |
| G201 | Behind right side of dash. See Figure. |
| G202 | Behind left side of dash. See Figure. |
| G300 | Below left "B" pillar. See Figure. |
| G301 | Below right "B" pillar. See Figure. |
| G302 | On right front of cargo pan. See Figure. |
| G303 | On right rear cargo pan. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
