Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Windows: Description
The power window system allows each of the door windows to be raised and lowered electrically by actuating a switch on the trim panel of each respective door. A master switch on the driver side front door trim panel allows the driver to raise or lower each of the passenger door windows and to lock out the individual switches on the passenger doors from operation. The power window system receives battery feed through a 30 amp circuit breaker in the junction block, only when the ignition switch is in the RUN position.
The power top switch (JR27 only) has three distinct functions:
- Top Down - Β This is the first detent on the down side of the switch. Holding the switch in this position will lower the top only.
- Top Down/4 window down - Β This is the second detent on the switch. Holding the switch in this position lowers the convertible top and all 4 windows down simultaneously only if held in this position.
- Top Up - Β Holding the switch in this position raises the convertible top to the closed position. It will also lower all 4 windows approximately 3 inches to prevent seal damage.
The power window system includes the power window switches on each door trim panel, the circuit breaker in the junction block and the power window motors inside each door. For service of mechanical components, such as the regulator, lift plate, window tracks or glass, refer to INTERIOR/EXTERIOR .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
