Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Sebring Limited, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Ignition Control: Specifications: Torque
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| 2.0/2.4L Target Magnet Screw | 3 | - | 30 |
| 2.4L Camshaft Sensor Screw | 13 | - | 115 |
| 2.0L Camshaft Sensor Screw | 9 | - | 80 |
| 2.7L Camshaft Sensor Screw | 12 | - | 105 |
| 2.0/2.4L Ignition coil bolts | 12 | - | 105 |
| 2.7L Ignition coil bolts | 7.5 | - | 65 |
| 2.4L Spark Plugs *(Torque Critical) | 17.5 +/-2 | 13 +/-2 | - |
| 2.7L Spark Plugs | 17.5 | 13 | - |
| Knock Sensor | 10 | 7 | - |
| Ignition Coil Capacitor Nut | 12 | 9 | 106 |
| Transmission mounting bolt | 61 | 45 | - |
| * Tapered seat plugs. Imperative that torque is NOT EXCEEDED. | |||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.