Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering System: Column: Column: Description
The steering column mounted to the underside of the instrument panel is a tilt type. See Fig 1. It has been designed to be serviced only as an assembly if it is determined to be defective. These replaceable components mounted on the steering column can be serviced without removal of the steering column from the vehicle:
- key cylinder
- lock cylinder trim ring
- ignition switch
- multi-function switch
- clockspring
- SKIM module
- trim shrouds, and
- steering wheel
The steering column intermediate shaft can also be serviced separately from the steering column.
The speed control switches and driver airbag mounted on the steering wheel are also serviced separately.
| 1 - INSTRUMENT PANEL |
| 2 - STEERING COLUMN |
| 3 - INTERMEDIATE SHAFT |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
