Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Air Injection: Pump: Removal

Disconnect negative battery cable.
Remove air inlet tube for the air cleaner box.
Disconnect quick connect hose from the top of the air pump.
Raise vehicle and support.
Remove 3 mounting nuts. See Fig 1.

Fig 1: Air Pump Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Unlock electrical connector. See Fig 2.

Fig 2: Electrical Connector Locking Tab
Courtesy of DAIMLERCHRYSLER CORP.
Unclip electrical connector from mounting bracket. See Fig 3.

Fig 3: Connector Retaining Clip
Courtesy of DAIMLERCHRYSLER CORP.
Press tab and disconnect electrical connector. See Fig 4.

Fig 4: Depress Tab On Connector
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect quick connect hose from inlet of the air pump.
Remove air pump from vehicle. See Fig 5.

Fig 5: Air Pump Removed

Courtesy of DAIMLERCHRYSLER CORP.

Chapter Navigation

Return to Chapter: Pump

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.