Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Mass Air Flow Sensor: Removal

Disconnect negative battery cable.
Remove the air pump assembly, (Refer to EMISSIONS CONTROL/AIR INJECTION/PUMP - REMOVAL) .
Remove 2 bracket mounting bolts. See Fig 1.

Fig 1: Mounting Bracket Bolts
Courtesy of DAIMLERCHRYSLER CORP.
Remove the bracket assembly. See Fig 2.

Fig 2: Remove/Install Assembly
Courtesy of DAIMLERCHRYSLER CORP.

Disconnect the electrical connector to MAF. See Fig 3.

Fig 3: Mass Air Flow Sensor

Courtesy of DAIMLERCHRYSLER CORP.

1 - Mass Air flow Sensor (MAF)

2 - Relay

2 - Inlet Filter

Twist the MAF sideways and remove from bracket. See Fig 4.

Fig 4: Removing/Installing Sensor From Bracket
Courtesy of DAIMLERCHRYSLER CORP.
Remove the rubber mounting.

Chapter Navigation

Return to Chapter: Mass Air Flow Sensor

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.