Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Connecting Tube: Removal

Remove air inlet duct to air cleaner box. See Fig 1.
Squeeze the quick connect on the tube to release it. See Fig 2.
Disconnect connector tube at air pump and one way check valve. See Fig 3 and Fig 4.
Remove connector tube, note routing of tube.

Fig 1: Air Cleaner Inlet Tube

Courtesy of DAIMLERCHRYSLER CORP.

Chapter Navigation

Return to Chapter: Connecting Tube

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.