Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE
Fuel Pump Module: Installation
- Wipe seal area of tank clean and place a new seal in position in the tank opening.
- Position fuel pump in the tank.
- Position the lock ring over the fuel pump module.
- Tighten the lock ring using a brass punch and hammer.
- Connect the electrical connector.
- Connect the fuel line to the fuel pump.
- Install the fuel tank, refer to INSTALLATIONÂ .
- Lower vehicle.
- Connect the battery cable.
- Fill fuel tank. Use the DRB III® scan tool to pressurize the fuel system. Check for leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.