2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Air Bag Control Module (ORC) (Base) Center of floor, near shifter assembly. See Figure .
Air Bag Control Module (Premium) Center of floor, near shifter. See Figure .
Anti-Lock Brake Module At lower left front of engine compartment. See Figure .
Blower Motor Power Module (ATC) At right end of HVAC. See Figure .
Body Control Module At left kick panel. See Figure .
Daytime Running Lamp Module On junction block. See Figure .
Fuel Pump Module On top of fuel tank.
Mode Door Actuator At left end of HVAC housing.
Occupant Restraint Controller Under floor console, behind transaxle gear selector.
Passenger Heated Seat Module Under passenger seat.
Powertrain Control Module Left front of engine compartment. See Figure .
Remote Keyless Entry Receiver On junction block.
Sentry Key Immobilizer Module On steering column. See Figure .
Sun Roof Control Module In left headliner. See Figure .
Chapter Navigation
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.