2006 Chrysler Sebring GTCFACTORY OEM SERVICE PROCEDURE

Power Distribution Center: Description

All of the electrical current distributed throughout this vehicle is directed through the standard equipment Power Distribution Center (PDC). The molded plastic PDC housing is located in the left front corner of the engine compartment. The PDC housing has a molded plastic cover that is retained by two latches.

A small red molded plastic protective cover on the top near the front of the PDC is unsnapped to access the battery/generator cable input connection stud. All of the PDC outputs are through the integral headlamp/dash wire harness, which exits from the rear of the PDC housing.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.