Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chrysler PT Cruiser Base, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE

Glow Plug: Removal

Fig 1: Location Of Battery

Courtesy of DAIMLERCHRYSLER CORP.

1 - BATTERY

2 - PASSENGER SEAT

Disconnect negative battery (1) cable.

Fig 2: Engine Cover And Mounting Fasteners

Courtesy of DAIMLERCHRYSLER CORP.

1 - ENGINE COVER RETAINING NUTS

2 - ENGINE COVER

3 - ENGINE COVER MOUNTS

4 - ENGINE COVER MOUNTING STUDS

Remove engine cover (2).

Fig 3: GLOW PLUG LOCATION - TYPICAL
Courtesy of DAIMLERCHRYSLER CORP.

1 - GLOW PLUG ELECTRICAL CONNECTOR

2 - GLOW PLUG

NOTE: Before removing glow plugs, blow off the top of the engine with compressed air.
Disconnect glow plug electrical connector (1). See Fig 3.
Remove glow plug (2) from cylinder head. See Fig 3.

Chapter Navigation

Return to Chapter: Glow Plug

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.