Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler PT Cruiser Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Switch: Installation
- Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
- Carefully install the ignition switch. The switch will snap over the retaining tabs. See Fig 1. Install mounting screw. See Figure.
- Install electrical connectors to ignition switch.
- Install the multi-function switch and tighten the 2 screws. See Figure.
- Install upper and lower shrouds.
- Install key cylinder (cylinder retaining tab will depress only in the RUN position).
- Connect negative cable to battery.
- Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
1 - LOCK CYLINDER HOUSING 2 - SHAFT - Check for proper operation of ignition switch and key-in warning switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.