2006 Chrysler PT Cruiser Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

1/2 Downstream - 2.0/2.4L

The downstream heated oxygen sensor threads into the exhaust pipe behind the catalytic convertor. See Fig 1.

Fig 1: Locating Oxygen Sensor (1/1 Upstream & 1/2 Downstream)
GC0021612Courtesy of DAIMLERCHRYSLER CORP.
1 - DOWN STREAM O2 SENSOR
2 - UP STREAM O2 SENSOR
  1. Remove the air cleaner lid and makeup air hose.
  2. Remove the negative battery cable.
  3. Raise vehicle and support.
  4. Disconnect electrical connector from sensor.
  5. Disconnect sensor electrical harness from clips along body.
    Fig 2: Downstream Heated Oxygen Sensor Removal/Installation
    GC0019485Courtesy of DAIMLERCHRYSLER CORP.
    1 - DOWNSTREAM HEATED OXYGEN SENSOR
    2 - CATALYTIC CONVERTOR
  6. Remove sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.