2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Passenger Airbag: Installation

Fig 1: Disconnecting/Connecting Negative Battery Cable
GC0035079Courtesy of DAIMLERCHRYSLER CORP.
  1. Verify the negative battery cable (2) is disconnected before proceeding. Wait two minutes for the system capacitor to discharge before further service.Β 
    Fig 2: Locating Passenger Airbag Bolts
    GC0035690Courtesy of DAIMLERCHRYSLER CORP.
  2. Carefully position the passenger airbag unit onto the instrument panel.
  3. Install the four bolts (1) that secure the passenger airbag to the instrument panel. Tighten to 35 N.m (26 ft. lbs.).
    Fig 3: Identifying Passenger Airbag Squib Harness Connector
    GC0035689Courtesy of DAIMLERCHRYSLER CORP.
  4. Connect the passenger airbag squib harness connector (1).
    CAUTION: Use caution when connecting the squib harness connector to the passenger airbag inflator connector receptacle. Improper assembly of these pigtail wires and their connector insulators can result in damage to the airbag circuits or connector insulators.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.