2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Section 33 (Speed Control): Switch: Removal

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.

The speed control switch is mounted to the back of the multi-function switch. The multi-function switch must be removed first to gain access to the speed control switch mounting screw. See Fig 1.

  1. Remove and isolate negative battery cable from battery.
  2. Remove multifunction switch.
  3. Remove switch mounting screw. See Fig 2.
  4. Remove speed control switch from multi-function switch.
  5. Unplug pigtail electrical connector from instrument panel wiring harness. See Fig 1.
Fig 1: SPEED CONTROL SWITCH LOCATION
GC0037619Courtesy of DAIMLERCHRYSLER CORP.
1 - SWITCH HANDLE
2 - PIGTAIL ELECTRICAL CONNECTOR
3 - MULTI-FUNCTION SWITCH
Fig 2: SPEED CONTROL SWITCH REMOVAL/INSTALLATION
GC0037620Courtesy of DAIMLERCHRYSLER CORP.
1 - SWITCH MOUNTING SCREW (1)
2 - SPEED CONTROL SWITCH
3 - SWITCH HANDLE
4 - MULTI-FUNCTION SWITCH
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.