Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Air Pump: Removal: Notes

Fig 1: Locating Switchover Tube & Harness Connector

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect the negative battery cable.
Remove the air cleaner housing.
Disconnect the air pump switchover tube (1).
Disconnect the air pump harness connector (2).

Fig 2: Locating Retaining Bolt & Bracket (3.2L)
Courtesy of DAIMLERCHRYSLER CORP.
Remove the air pump retaining bolt (2).
Remove the air pump (1) from the air pump retaining bracket (3).

Chapter Navigation

Return to Chapter: Removal

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.