Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
DTCS P0571 To P0753
- Diagnosis And Testing
- P0571 - Stop Lamp Switch Can Signal Lost To Trans Performance
- P0571 - Stop Lamp Switch Signal Performance
- P0575 - Speed Control Switch Input Circuit
- P0600 - No Can Message From Cab Module
- P0600 - No Transmission Bus Message
- P0600 - Lost Communication With Shift Lever Assembly (SLA)
- P0600 - No Cluster Bus Message
- P0602 - Pcm Programmed Incorrect Trans/No Comm From TCM
- P0606 - Internal Pcm Processor
- P0660 - Boost Pressure Control Unit
- P0700 - Transmission Control System (Mil Request)
- P0702 - Transmission Control Module Low Voltage
- P0702 - Transmission Control System (Mil Request)
- P0702 - Loss Of Torque Management Signal
- P0702 - TCM Torque Management Request Performance
- P0705 - SLA Control System (Mil Request)
- P0705 - Transmission Control System (Mil Request)
- P0715 - Transmission Control System (Mil Request)
- P0720 - Transmission Incorrect Torque Request From Esp
- P0720 - Transmission Control System (Mil Request)
- P0730 - Transmission Control System (Mil Request)
- P0740 - Transmission Control System (Mil Request)
- P0743 - Transmission Control System (Mil Request)
- P0748 - Transmission Control System (Mil Request)
- P0753 - Transmission Control System (Mil Request)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.