Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Ignition Coil: Removal: Notes
- Disconnect the negative battery cable (2).
- Remove the air cleaner inlet tubes (2).
- Remove the engine cover (1). Grasp both corners of the engine cover, and pull up firmly.
- Disconnect the ignition coil wire harness connector (1).
- Disconnect the spark plug cables (4) from the spark plugs.
- Remove the ignition coil retaining bolt (2).
- Remove the ignition coil (3) from the cylinder head cover.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.