2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Fuel Tank: Removal

Fig 1: Identifying Fuel Filter/Fuel Pressure Regulator & Fuel Hoses
GC0032316Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle.
  3. Remove the fuel pump splash shield.
  4. Drain the fuel tank. (Refer to FUEL SYSTEM/FUEL DELIVERY - STANDARD PROCEDURE)Β .
  5. Disconnect the fuel feed hose (4) from the bottom of the fuel tank.
  6. Disconnect the fuel return hose from the bottom of the fuel tank.
  7. Remove the cargo area trim panels.
    Fig 2: Identifying Fuel Tank Level & Pressure Sensor Connectors & Fuel Tank Partition Retaining Bolts
    GC0032323Courtesy of DAIMLERCHRYSLER CORP.
  8. Remove the fuel tank partition retaining bolts (2) and remove the fuel tank partition.
  9. Disconnect the fuel tank level and pressure sensor connectors (1) from the fuel sending unit.
  10. Disconnect the fuel tank filler neck cup seals from the body.
  11. Remove the fuel tank.
    NOTE: Inspect the strainer and O-ring for damage and replace as necessary.
  12. Remove the fuel strainer from the bottom of the fuel tank and inspect.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.