2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Fuel Injector: Removal

Fig 1: Identifying Fuel Injector & Fuel Rail Components
GC0032329Courtesy of DAIMLERCHRYSLER CORP.
1 - WIRING HARNESS COVER
2 - FUEL RAIL
3 - FUEL LINE
4 - FUEL INJECTOR
5 - FUEL INJECTOR RETAINING CLIP
6 - FUEL INJECTOR HARNESS CONNECTOR
7 - FUEL RAIL SERVICE VALVE
8 - FUEL RAIL BOLT
  1. Disconnect the negative battery cable.
  2. Remove the engine cover. (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL) or (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - REMOVAL) SRT.
  3. Remove the wiring harness cover retaining screw, and then remove the wiring harness cover (1).
  4. Release the fuel pressure through the fuel rail service valve (7) using a fuel pressure tester. Collect the fuel in a suitable container.
  5. Disconnect the fuel feed line (3).
  6. Remove the fuel injector wire harness connector retaining clips and then disconnect the fuel injector harness (6) from the fuel injectors (4).
  7. Remove the fuel rail retaining bolts (8).
  8. Remove the fuel rail (2) with the fuel injectors (4) by moving the fuel rail (2) side to side while lifting upward.
  9. Remove the fuel injector retaining clips and the fuel injectors (4) from the fuel rail (2).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.