2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Installation - SRT

Fig 1: Removing/Installing Manifold Absolute Presure Sensor & Supercharger Outlet Housing
GC0032357Courtesy of DAIMLERCHRYSLER CORP.
  1. Install the MAP sensor (1).
  2. Install the MAP sensor mounting bolts. Tighten to 4.5 N.m (40 in. lbs.).
  3. Connect the MAP sensor (1) harness connector.
  4. Install the supercharger outlet housing (2). Tighten the supercharger outlet housing hose clamps.
    Fig 2: Removing/Installing Throttle Body
    GC0032356Courtesy of DAIMLERCHRYSLER CORP.
  5. Install the throttle body. (Refer to FUEL SYSTEM/FUEL INJECTION/THROTTLE BODY - INSTALLATION) .
    Fig 3: Removing/Installing Intake Plenums
    GC0032355Courtesy of DAIMLERCHRYSLER CORP.
  6. Install both right and left intake plenums. (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) .
    Fig 4: Removing/Installing Lower Air Cleaner Housing
    GC0032354Courtesy of DAIMLERCHRYSLER CORP.
  7. Install both right and left lower air cleaner housings. (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION) .
    Fig 5: Removing/Installing Upper Air Cleaner Housing
    GC0032345Courtesy of DAIMLERCHRYSLER CORP.
  8. Install the upper air cleaner housings. (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION) .
  9. Install the engine cover. Align the engine cover retaining clips to the rubber mounts, and push down firmly to connect engine cover to rubber mounts.
    NOTE: To ease the installation of the engine cover, apply a small amount of lubricant to the engine cover rubber mounts.
  10. Connect the negative battery cable.
Chapter Navigation
Return to Chapter: Installation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.