2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Fuel Delivery: Installation

Fig 1: Identifying Fuel Filter/Fuel Pressure Regulator & Fuel Hoses
GC0032316Courtesy of DAIMLERCHRYSLER CORP.
  1. Install the fuel pump into the clamp, install the clamp retaining screw and tighten.
  2. Install the fuel pump harness connectors.
  3. Install both the fuel suction hose (4) and the fuel delivery hose to the fuel pump and tighten.
  4. Install the fuel pump splash shield.
  5. Lower the vehicle.
  6. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.