2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Exhaust System: Muffler: Installation: Notes

Fig 1: Locating Exhaust Hangers, Muffler & Exhaust Pipes
GC0032297Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the muffler section in the rubber exhaust hangers (1).
    Fig 2: Removing/Installing Bolts From Center Connection Flange
    GC0032294Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the bolts in the center exhaust flange (2). Tighten the bolts to 20 N.m (15 ft. lbs.).
    Fig 3: Disconnecting/Connecting Ground Strap At Muffler
    GC0032295Courtesy of DAIMLERCHRYSLER CORP.
  3. Connect the ground strap (1) at the muffler and tail pipe. Tighten the ground strap bolt to 10 N.m (89 in. lbs.).
  4. Remove the support.
  5. Install the rear support bracket. (Convertible only) (Refer to FRAME & BUMPERS/FRAME/BRACKET - INSTALLATION) .
  6. Lower the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.