Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Charging System: Generator: Installation
| 1 - GENERATOR |
| 2 - UPPER GENERATOR BOLT |
| 3 - LOWER GENERATOR BOLT |
| 4 - ELECTRICAL CONNECTOR |
| 5 - GENERATOR B+ PROTECTIVE PLASTIC CAP |
- Connect the generator B+ cable with the retaining nut and connect the generator harness connector (4). Tighten the generator B+ cable retaining nut to 15 N.m (11 ft. lbs.).
- Install the protective plastic cap on the generator B+ cable nut (5).
- Install the generator (1) into the mounting bracket.
- Install the upper and lower generator mounting bolts. Tighten the generator mounting bolts to 42 N.m (31 ft. lbs.).CAUTION: Be sure to check proper installation on all pulleys.
- Install the accessory drive belt. (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
- Install the right side air inlet tube.
- Connect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.