2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Transmission Control Module: Removal

Fig 1: Locating Foam Insulating Panel
GC0034838Courtesy of DAIMLERCHRYSLER CORP.
  1. Un-snap and remove the carpet floor mat.
  2. Fold back the carpeting in the passenger footwell to expose the foam insulation panel.
  3. Remove the foam insulation panel.
    Fig 2: Identifying Retaining Nuts
    GC0034836Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.