2006 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Security System Module: Removal

Fig 1: Identifying Interior Trim Panels And Floor Covering
GC0035005Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect the negative battery cable.
  2. Remove the trunk floor carpet.
  3. Remove the right side interior trim panel (4).
  4. Remove the upper right roof trim panel (1).
  5. Remove the rear interior trim panel (2).
  6. Remove the right half of the floor covering (3).
  7. Remove the sound deadening foam material from the central locking pump/security system module.
    Fig 2: Identifying Electrical Harness, Air Lines & Central Locking Pump/Security System Module
    GC0035001Courtesy of DAIMLERCHRYSLER CORP.
  8. Disconnect the air lines (2) and the electrical harness (1) from the central locking pump/security system module (3) and remove the module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.