Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE

Emissions Control System: Valve: Removal: 3.5L

Fig 1: EGR VALVE

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect the negative and then the positive battery cable.
Remove battery.
Unlock and disconnect the electrical connector from the EGR valve. See Fig 1.

Fig 2: EGR VALVE AND TUBE
Courtesy of DAIMLERCHRYSLER CORP.
Remove the 2 EGR tube bolts. See Fig 2.

Fig 3: EGR VALVE REMOVED
Courtesy of DAIMLERCHRYSLER CORP.
Remove the 2 mounting bolts for the EGR valve and gasket. See Fig 3.

Chapter Navigation

Return to Chapter: Removal

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.