Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE
Emissions Control System: Valve: Installation: 3.5L
- Install the 2 mounting bolts into the EGR valve and gasket. See Fig 1.
- Loose install the EGR valve to cylinder head.
- Loose install the EGR tube to EGR valve. See Fig 2.
- Tighten the EGR upper tube to EGR valve bolts to 11.3 N.m (100 in. lbs.) torque.
- Connect and lock the electrical connector for the EGR valve. See Fig 3.
- Install the battery.
- Connect the positive then the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.