Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE

Fuel Pump Module: Installation

Install fuel pump module into fuel tank.
Connect siphon and fuel line to fuel pump module. See Fig 1.

Fig 1: Pump With Top Removed
Courtesy of DAIMLERCHRYSLER CORP.
Connect fuel pump electrical connector to bottom of module top. See Figure.
The wire connector to the passenger side level sensor needs to be connected.
Install fuel pump module top to module. See Fig 2 and. See Fig 3.

Fig 2: Module Top Alignment Pins
Courtesy of DAIMLERCHRYSLER CORP.

Chapter Navigation

Return to Chapter: Fuel Pump Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.