2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE

Fuel Level Sending Unit / Sensor: Removal

  1. Release the fuel pressure, refer to the STANDARD PROCEDURE - FUEL SYSTEM PRESSURE RELEASE PROCEDUREΒ  .
  2. Disconnect negative battery cable.
  3. Remove fuel tank, (Refer to FUEL SYSTEM/FUEL DELIVERY/FUEL TANK - REMOVAL)Β .
  4. Vacuum area before removing module lock ring.
  5. Disconnect vapor line and electrical connector.
  6. Module lock ring contact points. See Fig 1.
    Fig 1: Locking Ring Contact Points
    GC0000364Courtesy of DAIMLERCHRYSLER CORP.
  7. NOTE: Use a brass punch to remove the 1/4 turn lock ring.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.